Jump to content
SnapPuppy

XT3 and the XT2 L bracket

Recommended Posts

So I'm hoping to have my XT3 next week and while I wait I was looking at those XT2 'L' brackets that have the little extra grip on them and got to wondering if they fit the XT3. 

Has the shape of the grip area on the XT3 changed at all to the XT2

This is the type of bracket.

71kDaEgZAqL._SX466_.jpg

Share this post


Link to post
Share on other sites

The XT3 is almost a fit but about 1 - 2 mm too long for the base part of the XT2 (Fuji) brackets. It may be forced but will likely damage the finish. If - with the (non-Fuji) bracket above - the camera sits on rather than in the base then you may be lucky especially if you loosen the vertical bracket to fit the base and then tighten the end part.

It really is poor service that Fuji makes users buy new brackets when I'm sure they could have shaved a mm or so off the base.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recommended Discussions



×
×
  • Create New...